From CAD to Client at DMEMS 2026: 20 Functional Lamps in 30 Days

At DMEMS 2026 in Del Mar, Cornel Manole showed how OCMEE delivered 10 functional auxiliary light sets, 20 lamps, in 30 days for a vehicle reveal.

April 22, 2026 | Del Mar, California, USA

At the Del Mar Electronics & Manufacturing Show (DMEMS) 2026, Cornel Manole, CTO and Co-Founder of OCMEE Design, presented From CAD to Client: Building Functional Auxiliary Light Prototypes for an Automotive OEM in Room C, Mission Towers, at the Del Mar Fairgrounds.

Cornel Manole at the podium with the From CAD to Client title slide, DMEMS 2026

The call

The talk started with a real request: could we build 10 sets of functional auxiliary lights in 30 days for a vehicle reveal? Other suppliers had declined functional work, and the only quote that came back was $28,000 for non-functional dummy shells. The reveal date could not move. We said yes.

How we built it

Week one was feasibility: lamp geometry, LED configuration, housing printability, circuit requirements, sourcing and assembly time. Week two turned that into a firm commitment. The final two weeks were production.

A custom PCB was not possible in 30 days, so we did not start from a blank part file. We tested five to six commercial donor parts, picked two, and designed the housings around electronics that already worked:

  • FDM-printed PC-ABS housings at 0.2 mm layers, with 2.5 mm minimum walls for rigidity and insert pull-out strength
  • M4 heat-set brass inserts pressed at 200 °C
  • Lenses bonded with 3M DP100 Clear epoxy and clamped for 24 hours
  • The donor board’s smoothing capacitor reused to stop visible flicker on vehicle 12 V
Cornel Manole holding a functional auxiliary lamp prototype during his DMEMS 2026 talkCornel Manole presenting CAD and design decisions at DMEMS 2026
DMEMS 2026 slide: CAD and design decisions for the lamp housings

What went wrong, and what fixed it

The donor LED strip had a dark band where the PCB carries electronics instead of LEDs, and it showed through the lens. Diffusers washed out the lit zone. The fix was in the CAD: a hidden pocket in the housing that tucks the dead zone out of sight. Mid-program the client also asked for a pulsing mode, so we added a small cavity for an off-the-shelf strobe controller and bench-tested every mode before delivery.

Each engineering decision was mapped to the failure mode it addressed in a six-risk DFMEA, which the audience spent the most time on.

Audience watching the DFMEA decision slide at DMEMS 2026
DMEMS 2026 slide: DFMEA with six risks and six decisions

The result

10 functional sets delivered. 20 lamps. 30 days. On time.

Q&A slide: 10 functional sets, 20 lamps, 30 days, on time

The lesson Cornel closed with applies well beyond lighting: do not manufacture what you can borrow. If a commercial product solves most of the electrical and packaging problem, redesign around it and spend your engineering on the parts that are actually new.

DMEMS 2026 slide: what I would do differently, five lessons

If your program needs CAD designed for assembly, low-volume functional prototypes or small-batch builds, talk to us →

Leave a Reply

Your email address will not be published. Required fields are marked *

Fill out this field
Fill out this field
Please enter a valid email address.